RMS Threshold Calibration
- Configuration
- RMS Threshold Calibration
MQTT disconnected
Select a node to begin.
Left Pressure Sensor
-- psi
Right Pressure Sensor
-- psi
RMS Left
--
RMS Right
--
Speed
-- km/h
Current Condition:
--
--
--
--
--
--
Step 1 — Collect Baselines on Vehicle
⬤ Idle
Park the vehicle on a flat, stationary surface.
Click Start Empty (unloaded) or Start Loaded.
Wait at least 60 seconds then click Stop & Calculate.
The TireSync Module runs the math and sends results here automatically.
Collecting…
0 samples
EMPTY
Unloaded Baseline
Pending
No data yet — collect an EMPTY session above.
LOADED
Loaded Baseline
Pending
No data yet — collect a LOADED session above.
Step 2 — Apply Baseline to IoT Node
Step 3 — Configure & Publish Thresholds
Low thresholds auto-computed from baseline
Load Detection Threshold (loaded_baseline) =
— midpoint of empty & loaded avg pressure
Midpoint pressure to detect load state
Left/right ratio for one-sided classification
Min interval between events
Ignore detection below this speed
EMPTY
Detection Thresholds (g RMS)
auto
Auto = 2 × std of empty baseline
Set after road test
Set after road test
LOADED
Detection Thresholds (g RMS)
auto
Auto = 2 × std of loaded baseline
Set after road test
Set after road test
Published to Vehicle